Dell S3100 Series Manual de introducción - Página 19
Navegue en línea o descargue pdf Manual de introducción para Interruptor Dell S3100 Series. Dell S3100 Series 27 páginas.
También para Dell S3100 Series: Manual de introducción (46 páginas), Manual de instalación (45 páginas)
Imprimir página
Console Port RJ-45 to
RJ-45
Rollover
Cable
Signal
RJ-45 Pinout RJ–45 Pinout DB-9 Pin
RxD
6
NC
7
CTS
8
Default Configuration
A version of Dell Networking OS is pre-loaded on the system; however, the
system is not configured when you power up for the first time (except for the
default host name, which is Dell).
You must configure the system using the CLI.
Configuring Layer 2 (Data Link) Mode
To enable Layer 2 data transmissions through an individual interface, use the
switchport command in INTERFACE mode.
You cannot configure switching or Layer 2 protocols such as spanning tree
protocol (STP) on an interface unless the interface has been set to Layer 2
mode.
1.
Enable the interface.
INTERFACE mode
no shutdown
2.
Place the interface in Layer 2 (switching) mode.
INTERFACE mode
switchport
To view the interfaces in Layer 2 mode, use the show interfaces
switchport command in EXEC mode.
Installing the Software
RJ-45 to
RJ-45 to
RJ-45
DB-9 Adapter
Rollover
Cable
3
3
2
4
1
7
Terminal
Server Device
Signal
TxD
DTR
RTS
19