Miele DA 229-2 Manual de funcionamiento e instalación - Página 35

Navegue en línea o descargue pdf Manual de funcionamiento e instalación para Campana de ventilación Miele DA 229-2. Miele DA 229-2 40 páginas. Cooker
También para Miele DA 229-2: Instrucciones de uso e instalación (40 páginas)

Imprimir página

Electrical connection

All electrical work should be under-

taken by a suitably qualified and

competent person in strict accord-

ance with national and local safety

regulations.

Installation, repairs and other work

by unqualified persons could be

dangerous. The manufacturer can

not be held responsible for unauth-

orised work.

Ensure power is not supplied to the

appliance while installation or repair

work is being carried out.

U.K., IRL, NZ, ZA: The cooker hood is

supplied for connection to an a.c.

230 V single phase 50 Hz supply.

AUS: The cooker hood is supplied for

connection to an a.c. single phase

240 V, 50 Hz supply.

The voltage, rated load and fusing are

given on the data plate. This is visible

when the grease filters have been

removed. Ensure that these match the

household mains supply.

For U.K.: Connection should be made

either by a double pole fused spur con-

nection unit, or a fused plug and a suit-

able switched socket. The On-Off

switch should be easily accessible

after the appliance has been built in.

When switched off there must be an all-

pole contact gap of 3 mm in the switch

(including switch, fuses and relays ac-

cording to EN 60 335).

If the socket is not accessible after in-

stallation (depending on country) an ad-

ditional means of disconnection must

be provided for all poles.

For extra safety it is advisable to install

a residual current device (RCD) with a

trip current of 30 mA (in accordance

with DIN VDE 0664, VDE 0100 Section

739).

Do not connect via an extension lead.

If the appliance is fitted with a non-re-

wireable plug (BS 1363 UK) and the

socket outlets are not suitable for the

plug supplied, or if the existing plug

needs to be replaced by a new one,

the old plug will need to be cut off and

an appropriate plug fitted. The fuse car-

rier and the fuse should be removed

from the old plug and disposed of. The

plug cut from the cable should then be

disposed of, and on no account be in-

serted into any socket elsewhere in the

house (electric shock hazard).

The fuse cover must be re-fitted when

changing the fuse and if the fuse cover

is lost the plug must not be used until a

suitable replacement is obtained.

The colour of the correct replacement

cover is that of the coloured insert in

the base of the plug or the colour that

is embossed in words in the base of

the plug (as applicable to the design of

plug fitted).

The correct fuse rating of the replace-

ment fuses that are ASTA approved to

BS 1362 should be fitted. Replacement

fuse covers may be purchased from

your local electrical suppliers or

Service agent.