Miele DA 424 V EXT Instrucciones de uso e instalación - Página 20

Navegue en línea o descargue pdf Instrucciones de uso e instalación para Campana de ventilación Miele DA 424 V EXT. Miele DA 424 V EXT 36 páginas. With extended canopy
También para Miele DA 424 V EXT: Instrucciones de uso e instalación (40 páginas), Dimensiones del producto (2 páginas), Manual de funcionamiento e instalación (36 páginas), Instrucciones de uso e instalación (36 páginas), Instrucciones de uso e instalación (36 páginas), Instrucciones de uso e instalación (40 páginas)

Imprimir página
Miele DA 424 V EXT Instrucciones de uso e instalación
Cleaning and care
Cleaning the grease filters by hand
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a small amount of washing-up
liquid.
Do not use:
– undiluted washing-up liquid,
– cleaning agents containing
descaling agents,
– powder cleaners, cream cleaners or
abrasive all-purpose cleaning
agents,
– oven sprays.
Cleaning the grease filters in the
dishwasher
^ Place the filters as upright as
possible in the lower basket. Ensure
the spray arm is not obstructed.
^ Do not wash at more than 65 °C. If a
Miele dishwasher is being used,
select the Sensor wash programme.
^ Use a mild dishwasher detergent.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
20
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
^ When putting the grease filters back
in position, ensure that the locking
clips are facing down towards the
cooktop.
If the grease filters are inadvertently
replaced upside down, insert a small
screwdriver blade into the slits to
disengage the clip.
^ After replacing the grease filters,
press the grease filter touch control
for approximately 3 seconds to re-set
the operating hours counter.
The indicator lamp will go out.
If the grease filters are cleaned before
the operating hours counter has
reached its maximum, the grease filter
touch control should be pressed for
approximately 6 seconds to reset the
counter.