ALLNIC AUDIO A-2000 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Amplificador ALLNIC AUDIO A-2000. ALLNIC AUDIO A-2000 13 páginas. Kt150 push-pull stereo power amplifier
También para ALLNIC AUDIO A-2000: Manual del usuario (9 páginas)
Imprimir página
• "On-the-Fly" Triode/Pentode Switching. Switching between triode and pentode operation can be done "on-the-
fly" at any time while the amplifier is in use.
• Beautiful 20KHz square wave response. See Figures 1-3.
Fig.1 Square Wave 50Hz*
• As are all Allnic Audio products, the A-2000 25th Anniversary SE is fully RoHS (EU Reduction of Hazardous
Substances regulation) compliant in construction and materials.
WHAT'S IN THE BOX?
Please check that the pair (assuming you purchased a pair) of shipping boxes contain the following:
•
One (1) Allnic A-2000 25th Anniversary SE Stereo Power Amplifier
•
One (1) each 15 amp IEC type power cord
•
One (1) Owner's Manual
Note:
1)
The A-2000 SE ships with the tubes installed.
2)
The A-2000 SE will work with most IEC type aftermarket power cords. The Allnic ZL-3000 and ZL-5000
power cables will make an excellent match. Of course, only you can determine the power cord that
works most synergistically with the A-2000 in your system.
3)
Be sure the A-2000 SE is labeled for the AC voltage of your location. If it is not, DO NOT connect it to
your AC outlet. Please contact your Allnic dealer.
We advise that you keep the boxes and other packing materials that your A-2000 SE came in. It will be useful if
you sell your A-2000 SE or in the unlikely event you need to ship it for service.
SAFETY
•
Remove ALL protective cushioning material (cardboard around the tubes) inside the tube chimneys
before operation. The tube chimneys should contain NOTHING except the tubes
leave the "O" rings, if any, on the small tubes; some prefer the sound with the O rings on).
•
Disconnect the power cord by pulling the plug, not the cable.
•
Do not attempt any repairs. Do not remove the unit's chassis cover without specific authorization from
your Allnic dealer.
•
Keep the power cord away from heat sources
•
Keep the unit away from liquids – do not allow any liquid to enter the interior of the unit.
*
Measured by LEADER LAG-126 Audio Signal Generator and KENWOOD CS-4125 Oscilloscope.
Fig.2 Square Wave 1KHz*
5
Fig.3 Square Wave 20KHz*
(It is optional to