ALLNIC AUDIO A-5000 NEO Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Amplificador ALLNIC AUDIO A-5000 NEO. ALLNIC AUDIO A-5000 NEO 8 páginas. 300b set monoblock power amplifier

Imprimir página

ALLNIC AUDIO A-5000 NEO Manual del usuario

TUBES AND TUBE BIAS

Each A-5000 NEO uses the following tubes:

 Two (2) x 300B

 One (1) x 6GV8

Because of the individual bias for each 300B, it is not

necessary to use a matched pair in the A-5000 NEO.

If the current meter, when switched to one or the other of

the unit's 300B's, has moved to the left of the parallel lines on

the meter face, using an appropriately bladed screwdriver,

adjust the potentiometer directly in front of that tube's

location by turning it clockwise until the needle has returned

to between the meter's parallel lines. If the meter needle has

moved to the right of the parallel lines on the meter face,

turn the potentiometer control counter-clockwise to correct.

If the meter's needle drops to the left limit of the meter's

face during operation, this indicates a failure of the related

300B tube. You must turn off the A-5000 NEO and replace

both the fuse (0.5A, 250V, 20mm glass type) for that tube and

the 300B. To replace a fuse, using a screwdriver, simply turn

the top of the fuse cap counter clockwise. It will spring out

holding the fuse. Replace the fuse, push the fuse cap down

and turn it clockwise; it will lock itself. If you have any

questions about doing this, please contact Hammertone

Audio for assistance.

You may use any 300B type tube in the A-5000 NEO, including

the newer higher voltage varieties. Of course, you will have to

adjust the bias back into the area between the two parallel

lines of the meter for a tube when it is replaced. Please refer

to Figure 6 for tube locations.

All consequences of changing or attempting to change tubes

are borne by the user unless by express agreement between

the owner and Hammertone Audio. Allnic Audio and

WARRANTY

All Allnic Audio amplifier products are warranted against materials and manufacturing defects for parts, excluding tubes, and

labour for two (2) years from date of purchase. Tubes are warranted against materials and manufacturing defects for one (1) year

from date of purchase. The warranty is transferable for the balance of the original purchaser's warranty period, provided, as

stated below, no unauthorized repairs or modifications have been performed on the product. Date of purchase is the date

indicated on the invoice for the product issued by Hammertone Audio.

For the warranty to be valid, a defective product must be returned to Hammertone Audio for service prior to any unauthorized

attempt to repair. Any repair work on an Allnic Audio product not specifically authorized by Hammertone Audio will void the

warranty on the product.

Hammertone Audio are not liable in any way whatsoever for

any injury or loss incurred by the user or for damage to the A-

5000 NEO, any of its parts, or tubes or replacement tubes

resulting from the user changing or attempting to change tubes.

SPECIFICATIONS FOR THE ALLNIC AUDIO A-5000 NEO 300B SET

MONOBLOCK POWER AMPLIFIER

 Output Power:

 Distortion:

 Frequency Response:

 S/N Ratio:

 Damping Factor:

 Voltage gain:

 Input Impedance:

 Input Sensitivity:

 Tubes:

 AC Fuse:

 Dimensions:

 Weight:

25w (8Ω or 4Ω load, at 1KHz)

0.3% at 1KHz, 2.83V

20Hz - 20KHz Flat

-80dB (CCIR, 1KHz)

10 at 8Ω load at 1KHz

+24dB

100KΩ (single-ended, unbalanced)

0.7V for rated power

300B X 2 (power triode)

6GV8 X 1 (driver tube - equivalent to

ECL85 and 6F5p)

15A, 250V (two supplied – one is a

spare)

(W x D x H) 430mm (16.93 inches) x

330mm ( inches) X 240mm

(9.45 inches)

20Kg (44 lbs) net per monoblock.

21.8 Kg (48 lbs) shipping weight per

monoblock.