Allo RemoteControl BECKER VC420 Instrucciones - Página 2

Navegue en línea o descargue pdf Instrucciones para Receptor Allo RemoteControl BECKER VC420. Allo RemoteControl BECKER VC420 2 páginas.

How to program BECKER VC420?

 Set the VC420 to programming mode by switching on the power

supply:

1. Switch on the power supply

2. The VC420 will remain in the programming mode for 3 minutes

 OR set the VC420 using the programming button:

1. Press and hold the programming button for 3 seconds

2. The VC420 will remain in the programming mode for 3 minutes

 Programming the master transmitter:

The master transmitter is the very first transmitter programmed on a receiver. It

NOTE:

enables the setting of limit positions (for drives with integrated radio receivers) and the

programming or deleting of further transmitters.

1. Press the programming button of the transmitter for 3 seconds

2. The system will confirm the program setting with a 'nod'. i.e. the shutter/awning/blind

moves a few centimeters in one direction and then reverses the same distance

3. The programming process is now complete

Visit our website : www.alloremotecontrol.com