ABB ACH580-01 Series Manual de instrucciones

Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial ABB ACH580-01 Series. ABB ACH580-01 Series 8 páginas. Base drive replacement
También para ABB ACH580-01 Series: Manual (16 páginas), Manual de instalación rápida y puesta en marcha (17 páginas), Manual de instrucciones (7 páginas), Manual de instalación rápida y puesta en marcha (17 páginas), Manual de instalación rápida y puesta en marcha (17 páginas)

Imprimir página
ABB ACH580-01 Series Manual de instrucciones
—
ACH580-01 BxR, UL Type 1/12
Frame R1/R2
Base drive replacement instructions
Purpose or Scope
The following are the instructions for replacing an ACH580-01 UL Type 1 and 12 (Frames
R1 & R2) drive in BxR enclosures.
Equipment required*:
– Replacement drive (see note below)
– T20 bit
– T30 bit
– PZ2 bit
– PZ3 bit
– Torque wrench
– Zip ties
Basic overview of steps
– Back-up drive parameters (if you can)
– Remove power and verify after 5 minutes
– Open enclosure
– Disconnect all wiring
– Remove flange plate
– Remove drive
– Prepare replacement drive
– Remove conduit assembly
– Install in reverse order
– Check connections
– Power drive
– Reprogram and test
Notes and cautions
CAUTION! Review complete safety and electrical considerations prior
to replacing the drive. See ACH580 IOM (3AXD50000049127).
CAUTION! Two people are recommended for this job. The drive is
heavy and can fall, causing property damage and injury.
NOTE: UL Type 12 drives require a UL Type 12 replacement drive,
UL Type 1 drives are not allowed as substitutes for UL Type 12.
* Not all of these tools are needed for each frame size.