Alloy ESM-24T02M Manual de instalación rápida - Página 4

Navegue en línea o descargue pdf Manual de instalación rápida para Interruptor Alloy ESM-24T02M. Alloy ESM-24T02M 5 páginas. Etherguard managed switch

Imprimir página

Setup the COM port properties by using the information below and click "OK".

Bits Rate per Second = 9600

Data Bits = 8

Parity = None

Stop Bit = 1

Flow Control = None

Connect the included serial cable from the computer's COM port to the Switch's

console port.

Power on the Switch and you will see some messages displayed in the

"HypertTerminal" window. The Switch's Power On Self Diagnostic (POSD) takes

about 100 seconds. After that, you will be presented with the login screen.

If the Switch is already powered on and finished its self-diagnostic, after running the

terminal communication program, please hit "Enter" once to get the login screen.

At "username" field type in

At "password" field type in

Switch's configuration program.

On the lower portion of the screen, you will see descriptions of the navigation keys

(e.g. Tab, Space Bar, and Enter). Please use these keys to move around the

configuration program.

For more information about the configuration settings, please refer to the User's Guide on

the CD-ROM.

Note: If there is no activity for 2 minutes the console program will automatically logout.

Please reenter the password and username to login.

In-Band Configuration via Ethernet Network

In addition to terminal mode configuration, the EMS-24T02M Switch also supports In-Band

Configuration using a Web Browser. You can simply connect a network-ready PC to the

Switch, open your web browser, go to the Switch's configuration page (Switch's IP address),

and configure the Switch by clicking the appropriate menu items.

Before you can access the switch through in-band, you must make sure the computer

connecting to the Switch has a web browser and the TCP/IP protocol (with valid IP address) is

bound to the network adapter. After that, you can either change your computer's IP address to

the same class as the Switch's IP address, or you can login to the Switch with the

"out-of-band" method described in the previous section and configure the Switch's IP address

to the same class as your computer's IP address.

Below, is the Switch's default IP information:

IP Address: 192.168.0.100

Subnet Mask: 255.255.255.0

Gateway: 192.168.0.1

admin

and hit "Enter".

admin

and hit "Enter". You are now logged into the

4 of 5