Miller ArcReach 16 Manual del usuario - Página 36

Navegue en línea o descargue pdf Manual del usuario para Sistema de soldadura Miller ArcReach 16. Miller ArcReach 16 48 páginas.

Imprimir página

6-3.

Cable Length Compensation (CLC)

Ref. 278794-A

OM-278792 Page 30

�

Complete Parts List is available at www.MillerWelds.com

�

CLC will only work with a compatible

power source.

�

Having a good clean connection with

the v-sense clamp will ensure CLC

works properly.

1 Cable

Length

Compensation

Indicator

Cable Length Compensation (ON)

After the feeder associates (see Section5-4

to the power source, CLC will appear in the

voltage display on the feeder. This indicates

the feeder is calculating for CLC. Within 5-10

seconds, preset voltage will appear on the

voltage display along with the CLC indicator

turning on.

Only the desired weld voltage needs to be

preset at the feeder without any manual

compensation for voltage loss in the weld ca-

bles. While welding the power source will au-

tomatically adjust it's voltage to compensate

for any voltage drop in the weld cables.

�

If the feeder is unable to calculate CLC

the indicator will flash. If this happens a

weld can be made and the CLC will be

calculated in the first few seconds of

the weld. The first few seconds of weld-

ing may be erratic due to the feeder

calculating CLC.

Turning Cable Length Compensation ON/

OFF

� Press and hold the Voltage Adjust knob

and the Wire Feed Speed adjust knob

simultaneously.

� P01 (P01 = CLC) will appear on the volt-

age display with either On or Off being

displayed on the wire feed speed/amps

display.

� Within 3 seconds, turn the Wire Feed

Speed adjust knob to toggle between

On and Off.

� When turned to On, the CLC indicator

will turn on within 3-5 seconds.

� When turned to Off, the CLC indicator

will turn off.

(CLC)