Axminster Woodturner's Clubman & Goliath Chucks Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Herramientas Axminster Woodturner's Clubman & Goliath Chucks. Axminster Woodturner's Clubman & Goliath Chucks 16 páginas.

Axminster Woodturner's Clubman & Goliath Chucks Manual del usuario
Basic Safety for Machine Tools...
DO NOT OVERREACH
Keep proper footing and balance at all times.
MAINTAIN TOOL WITH CARE
Keep tools sharp and clean at all times for the best and safest performance. Follow the
manufacturer's instructions for lubricating and sharpening and also for changing accessories.
DISCONNECT POWER FROM THE TOOL
Before servicing or when changing accessories always disconnect the power supply to avoid
accidental starting.
AVOID ACCIDENTAL START UP
Make sure switch is in "OFF" position before connecting the machine to the power supply.
USE RECOMMENDED ACCESSORIES
Consult the owner's manual for details of any manufacturer's accessories or contact your
supplier for details of recommended accessories. Follow the instructions that accompany
the accessory. The improper use of accessories may cause hazards. The fitting of
non-recommended accessories may also cause hazards.
CHECK DAMAGED PARTS
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to ensure that it will operate properly and perform its intended function. Check
for alignment of moving parts, breakage of parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged should be properly repaired
or replaced. A parts list is to be found at the back of your operator's manual.
NEVER LEAVE A MACHINE RUNNING UNATTENDED
ALWAYS turn power off. Do not leave machine until it comes to a complete stop.
DRUGS, ALCOHOL AND MEDICATION
NEVER operate tools whilst under the influence of drugs, alcohol or after taking medication.
USE THE CORRECT TOOL
Do not force a tool or attachment to do a job for which it was not designed. This is
dangerous workshop practice.
Specific Safety Instructions for the Chuck...
When using this chuck please follow the basic safety precautions
and observe the following specific precautions:-
DO ensure the chuck is screwed fully onto the headstock shaft.
DO ensure that all accessory fittings are secure before starting your lathe.
DO start the machine in a slow speed if the work is unbalanced.
DO make sure the chuck key or 'C' spanner are removed from the chuck before switching on.
DO be aware that when gripping large diameter workpieces that the jaws may extend beyond
the boundary of the chuck body.
DO keep your hands clear until the chuck has stopped rotating.
DO NOT attempt to exceed the normal capacity of any jaw fitted to the chuck as the jaws
may not fully engage the scroll if they are extended too far.
DO NOT run your lathe in reverse.
0800 371822
FREEPHONE
04