Epson ELPMB47 Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Proyector Epson ELPMB47. Epson ELPMB47 16 páginas.

Wire clip

Caution

After installing the safety wire, check the following points. If by any chance the wire is damaged,

replace it with a commercially available wire rope of 1.5 mm or more in diameter.

v The wire is not frayed or unraveling.

v The wire is not bent at an acute angle against the edge of the flat washer or

other object.

Caution

v If the supplied safety wires are too short for where you are installing the projector, use

commercially available wire ropes of 1.5 mm or more in diameter.

v Cut off any extra wire rope after installation.

Loosen the screws of the wire clip, and then

pass the end of the safety wire through the

wire clip and a hole on the projector plate.

Pull the end of the wire rope out from under

the projector plate and pass it through the

wire clip.

Stretch the safety wire as tight as possible

without causing the position of the projected

image to move, and then tighten the screws

of the wire clip loosely to secure the wire.

Perform steps 3 to 5 again for the other safety

wire and fix it to the projector plate as well.

After installing the safety wires, move each

wire clip in the direction shown in the

illustration and tighten the screws of the

clips.