Cisco 2525 Manual de configuración - Página 11

Navegue en línea o descargue pdf Manual de configuración para Enrutador de red Cisco 2525. Cisco 2525 23 páginas. Troubleshooting guide
También para Cisco 2525: Manual de configuración (23 páginas), Visión general (10 páginas), Preparación de la instalación (19 páginas), Manual de solución de problemas (4 páginas)

The ISDN BRI interface is configured to allow connection to ISDN WANs. To configure

the ISDN BRI interface, respond as follows (using your addresses and subnet mask) to the

setup prompts, substituting the correct addresses and host names as appropriate:

Configuring interface BRI0:

Is this interface in use? [yes]

Configure IP on this interface? [yes]

IP address for this interface: 172.16.71.1

Number of bits in subnet field [0]: 8

lass B network is 172.16.0.0, 8 subnet bits; mask is

Configuring the Ethernet or Token Ring Interfaces

Take the following steps to configure the Ethernet or Token Ring interface to allow

communication over a LAN. To configure the interface parameters, you need to know your

Ethernet or Token Ring interface network addresses. In this example, the system is being

configured for an Ethernet LAN using IP.

Step 1

255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]: 1

AppleTalk ending cable range [1]: 2

AppleTalk zone name [myzone]:

AppleTalk additional zone name: otherzone

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [1]: B000

Respond as follows (using your addresses and subnet mask) to the setup prompts,

substituting the correct addresses and host names as appropriate:

Configuring interface Ethernet0:

Is this interface in use? [yes]:

Configure IP on this interface? [yes]:

IP address for this interface: 172.16.72.1

Number of bits in subnet field [8]: 8

Class B network is 172.16.0.0, 8 subnet bits; mask is

255.255.255.0

Configuring the Cisco 2524 and Cisco 2525 Routers 4-11

Configuring the Router