Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manual de inicio rápido - Página 14
Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 páginas. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
Imprimir página
Collecting Required Tools and Supplies
Important Guidelines
Even though APs have been engineered for easy installation, there are some very important guidelines
to keep in mind:
•
•
•
•
•
•
•
When AP is configured with an IP address and is moved to a different
IP segment, it attempts to join a Cisco Wireless LAN Controller. If it
is unable to join a Cisco Wireless LAN Controller after a number of attempts, it does an arp for the
default configured gateway. If the AP is on the wrong subnet, it will not be able to resolve the gateway
arp and it will attempt to contact a DHCP server. This is the AP IP address fallback feature. However, if
the destination IP segment does not have a DHCP server, the AP retains its original IP address and can
never join the network.
Collecting Required Tools and Supplies
Listed below are the pre-installation tool required:
•
•
•
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
2
PLACE the AP NO MORE THAN 140 FEET APART. Placing them farther apart almost always
results in poor coverage.
DO NOT MOUNT APs OUTDOORS.
DO NOT MOUNT the APs ON BUILDING PERIMETER WALLS UNLESS THE OPERATOR
WANTS TO PROVIDE COVERAGE OUTSIDE THE BUILDING.
BE SURE that plenum-mounted APs are powered using Power over Ethernet (PoE) and use only the
metal brackets (not the Ceiling-Mount Base or the Hanging-Ceiling Clips) to comply with safety
regulations.
BE SURE THAT the APs ARE INSTALLED VERTICALLY.
Installing them vertically standing up in a plenum or hanging
from a ceiling creates the largest coverage area per AP. Hanging
the APs from the ceiling provides the best RF coverage.
DO NOT MOUNT the AP ANTENNAS WITHIN ONE METER
(3 FT.) OF ANY METAL OBSTRUCTIONS. THE RF WAVES
FROM the APs ARE BLOCKED AND/OR REFLECTED BY
METAL OBJECTS such as metal HVAC ducts, conduit, pipes,
bookcases, elevator shafts, stairwells, and metal walls. REFER
TO THE Cisco 1000 Series IEEE 802.11a/b/g Lightweight
Access Point Deployment Guide BEFORE MOUNTING the APs
NEAR METAL OBSTRUCTIONS.
WHEN MOUNTING the APs IN THE CORNER OF A
RIGHT-ANGLE HALLWAY INTERSECTION, MOUNT THE
them AT A 45-DEGREE ANGLE TO THE TWO HALLWAYS.
The AP internal antennas are not omnidirectional and cover a
larger area when mounted this way.
One AP per location.
AP Mounting Kits, factory-supplied with each AP.
Optional AP Mounting Kits, factory-orderable.
Installation and Configuration
1 meter (3 ft.)
clearance
7817146-01