Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manual de inicio rápido - Página 19

Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 páginas. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas

Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manual de inicio rápido
Installation and Configuration

Mounting the Access Points

Using the supplied or optional orderable AP mounting kits, mount each AP in its indicated location,
oriented as shown on the map. Note that you can mount the AP in the ceiling plenum or below the ceiling,
but that they perform best when mounted below the ceiling.
Note that the AP supports Antenna Sectorization, which can be used to increase the number of clients
and client throughput in a given air space. Installers can mount two APs back-to-back and the Network
operator can disable the second antenna in both APs to create a 360-degree coverage area with two
sectors.
The APs can be mounted in any one of the following configurations:

Ceiling Mount Base

When you are mounting the AP in the middle of a ceiling (flat sides toward the room or hallway), use
the ceiling-mount base to mount the AP as shown in the following figure and as described below:
Figure 4
1.
2.
3.
7817146-01
Ceiling Mount Base, page
Ceiling-Mount Clips, page
Projection Wall Mount, page
Flush Wall Mount, page
11.
Ceiling-Mount Bezel -- Refer to the Ceiling Mount Bezels for Cisco Aironet 1000 Series Lightweight
Access Points - Quick Start Guide.
Attaching the AP and Ceiling-Mount Base
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
Attach the ceiling-mount base to the bottom of the AP using the factory-supplied machine screws
and washers.
Position the ceiling-mount base so its keyhole slots are partly on the drywall, sheet metal, or other
screw heads installed in
"Preparing Mounting
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
7.
8.
10.
Locations".

Mounting the Access Points

7