Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manual de inicio rápido - Página 20

Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 páginas. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas

Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Manual de inicio rápido
Mounting the Access Points
If the screws do not securely hold the ceiling-mount base, remove the AP and adjust the screws until they
Note
hold the ceiling-mount base securely.
4.
Note
When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and
Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP is broadcasting its beacon
signal(s). When this happens, complete the installation as quickly as possible to remove yourself from
within 8 inches (20 cm) of the AP to comply with FCC RF radiation exposure guidelines.
5.
You have installed the AP . Repeat
with

Ceiling-Mount Clips

When you are mounting the AP on the extruded aluminium rails of a hanging ceiling, use the
ceiling-mount clips to mount the AP as shown in the following figure and as described below:
Figure 5
1.
2.
3.
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
8
Attach the cables to the sides of the AP.
Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it fits snugly
in place.
"Returning MAC
Information".
Assembling the AP and Ceiling-Mount Clips
Copy the MAC address(es) from the label(s) on the AP onto the corresponding location on the map.
MAC addresses have the format 00xxxxxxxxxx.
Attach the ceiling-mount clips to the bottom of the AP using the factory-supplied machine screws
and washers.
Snap the ceiling-mount clips onto a hanging ceiling rail.
"Mounting the Access
Points"
Installation and Configuration
for each AP location, and then continue
7817146-01