Cisco RSP7000 Instalación de - Página 23

Navegue en línea o descargue pdf Instalación de para Hardware de red Cisco RSP7000. Cisco RSP7000 26 páginas. Upgrade kit in the cisco 7000 series routers
También para Cisco RSP7000: Manual de instalación y configuración (48 páginas)

Imprimir página

Checking the RSP7000CI Installation

Verify that the RSP7000 is installed in the chassis' 7000 RSP slot (see Figure 1 on page 2 or Figure 2

on page 3). Verify that the RSP700CI is installed in the chassis' 7000 CI slot (see Figure 1 on page 2

or Figure 2 on page 3), and that the captive installation screws on both processor modules are

tightened.

Using the RSP7000CI and the temperature sensors on the RSP7000, the system displays warning

messages on the console if chassis interface-monitored parameters exceed a desired threshold or if

a blower failure occurs. You can retrieve and display environmental status reports with the show

environment, show environment all, show environment last and show environment table

commands. Parameters are measured and reporting functions are updated every 60 seconds. Use

these show commands to verify that the RSP7000CI installation was successful. A brief description

of each of these commands follows.

Caution

Overtemperature conditions can occur if the system is drawing in the exhaust air of other equipment.

Ensure adequate clearance around the sides of the chassis so that cooling air can ﬂow through the

chassis interior unimpeded. Obstructing or blocking the chassis sides will restrict the airﬂow and can

cause the internal chassis temperature to exceed acceptable limits.

The show environment command display reports the current environmental status of the system.

The report displays parameters that are out of the normal values. No parameters are displayed if the

system status is normal. The example that follows shows the display for a system in which all

monitored parameters are within Normal range.

Following is sample output of the show env command:

Router# show env

All measured values are normal

If the environmental status is not normal, the system reports the worst-case status level in the last

line of the display.

The show environment last command retrieves and displays the NVRAM log showing the reason

for the last shutdown (if the shutdown was related to voltage or temperature) and the environmental

status at that time. Air temperature is measured and displayed, and the DC voltages supplied by the

power supply are also displayed.An example of the show env last command follows for both the

Cisco 7000 and Cisco 7010:

RSP7000#sho env last

RSP7010#sho env last

To prevent overheating the chassis, ensure that your system is drawing cool inlet air.

CI(6) Inlet

previously measured at 22C/71F

CI(6) Hotpoint

previously measured at 31C/87F

CI(6) Exhaust

+12 Voltage

+5 Voltage

-12 Voltage

+24 Voltage

CI(4) Inlet

previously measured at 23C/73F

CI(4) Hotpoint

previously measured at 35C/95F

CI(4) Exhaust

previously measured at 25C/77F

+12 Voltage

previously measured at 12.31

+5 Voltage

previously measured at 5.17

-12 Voltage

previously measured at -11.89

+24 Voltage

previously measured at 23.78

previously measured at 23C/73F

previously measured at 12.12

previously measured at 5.13

previously measured at -11.84

previously measured at 24.06

Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

Checking the Installation