Cisco UCS B200 M3 Nota de instalación y mantenimiento - Página 4

Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Hardware de red Cisco UCS B200 M3. Cisco UCS B200 M3 28 páginas. Blade server
También para Cisco UCS B200 M3: Manual de instalación (34 páginas), Nota de instalación y mantenimiento (36 páginas), Nota de instalación y mantenimiento (37 páginas), Manual (8 páginas), Manual de actualización (21 páginas)

LED

Activity

(Disk Drive)

Health

(Disk Drive)

Buttons

The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper clip or a similar item.

Hold the button down for five seconds, and then release it to restart the server if other methods of restarting do not work.

The locator function for an individual server may get turned on or off by pressing the locator button/LED.

The front-panel power button is disabled by default. It can re-enabled through Cisco UCS Manager. After it's enabled, The power

button allows you to manually take a server temporarily out of service but leave it in a state where it can be restarted quickly. If the

desired power state for a service profile associated with a blade server is set to "off," using the power button or Cisco UCS Manager

to reset the server will cause the desired power state of the server to become out of sync with the actual power state and the server

may unexpectedly shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server action in Cisco

UCS Manager.

Local Console Connection

The local console connector allows a direct connection to a blade server to allow operating system installation and other management

tasks to be done directly rather than remotely. The port uses the KVM dongle cable that provides a connection into a Cisco UCS

blade server; it has a DB9 serial connector, a VGA connector for a monitor, and dual USB ports for a keyboard and mouse. With this

cable, you can create a direct connection to the operating system and the BIOS running on a blade server. A KVM cable ships standard

with each blade chassis accessory kit.

Figure 2: KVM Cable for Blade Servers

Color

Off

Green

Off

Flashing Amber 4 hz

Amber

Connector to blade server local

console connection

Description

Inactive.

Outstanding I/O to disk drive.

Can mean either no fault detected or the

drive is not installed.

Rebuild drive active.

If the Activity LED is also flashing amber,

a drive rebuild is in progress.

Fault detected.

DB9 serial connector