Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) Manual de instalación y configuración - Página 35
Navegue en línea o descargue pdf Manual de instalación y configuración para Hardware de red Cisco Versatile Interface Processor (VIP6-80) (VIP6-80). Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 40 páginas. Versatile interface processor
Imprimir página
Repeat
Step 8
This completes the DIMM removal procedure.
Installing SDRAM DIMMs
With the VIP6-80 handle away from you and the bus connector toward you, use the following procedure
to install the new DIMM in the DIMM socket:
Remove the new DIMM from its antistatic container.
Step 1
Step 2
Hold the DIMM between your thumbs and forefingers. (See
Note
Step 3
Insert the connector edge of the DIMM straight into the socket.
Caution
When inserting the DIMM, use firm but not excessive pressure. If you damage a socket, you will have
to return the VIP6-80 to the factory for repair.
Gently push the DIMM into the socket until the socket tabs close over the ends of the DIMM. (See
Step 4
Figure
Figure 11
Step 5
Check to see if the DIMM is seated properly. If the DIMM appears misaligned, carefully remove it and
reseat it in the socket. Push the DIMM firmly back into the socket until first one and then the other socket
tab moves into place.
Repeat
Step 6
This completes the DIMM replacement procedure. Reinstall the VIP6-80 in the system. (Follow the steps
in the
Memory
OL-5078-01
Step 4
through
Step 7
for the remaining DIMM, if required for your upgrade.
The 64-MB DIMM should be facing component-side down.
11.) If necessary, rock the DIMM gently back and forth to seat it properly.
Inserting the DIMM
Step 1
through
Step 5
above if you are replacing more than one DIMM.
"Installing a VIP6-80" section on page
Upgrade," as required.
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
Figure
8.)
24.) See the following section,
"Checking the VIP6-80
35