Cisco 2501 - Router - EN Manual de configuración - Página 5
Navegue en línea o descargue pdf Manual de configuración para Servidor Cisco 2501 - Router - EN. Cisco 2501 - Router - EN 19 páginas. Access server - chapter 4
También para Cisco 2501 - Router - EN: Manual del usuario (11 páginas)
Imprimir página
There are two commands you can use to do this, depending on the release you have of the
Cisco IOS software:
•
enable secret password (which is a very secure, encrypted password).
•
enable password (which is a less secure, or nonencrypted, password).
The enable secret password is available in Cisco IOS Release 10.2(3) or later. The enable
secret password is not available before Release 10.2(3). The enable password is available
in all releases. You must enter the correct password to gain access to privileged-level
commands.
On systems running Release 10.2(3) or later, the enable secret password is used. when you
are running from the boot ROM, the enable password might be used depending on your
ROM level.
The passwords should be different for maximum security. If you enter the same password
for both during the setup script, the system will accept it, but you will receive a warning
message indicating that you should enter a different password.
An enable secret password can contain from 1 to 25 uppercase and lowercase alphanumeric
characters; an enable password can contain any number of uppercase and lowercase
alphanumeric characters. In both cases, a number cannot be the first character. Spaces are
also valid password characters; for example, "two words" is a valid password. Leading
spaces are ignored; trailing spaces are recognized.
If you lose or forget your enable password, see the section "Recovering a Lost Enable
Password" in the chapter "Maintaining the Cisco 2500 Series Access Server."
Configuring the Access Server
You can configure the access server following one of the procedures described in the
following sections:
•
Configuring the Access Server Using the Configuration Mode
•
Configuring the Access Server Using AutoInstall
•
Configuring the Access Server Manually Using the Setup Facility
Follow the procedure that best fits the needs of your network configuration.
Configuring the Access Server
Configuring the Cisco 2500 Series Access Server 4-5