Cisco ONS 15454 Instale - Página 8

Navegue en línea o descargue pdf Instale para Servidor Cisco ONS 15454. Cisco ONS 15454 32 páginas. Four-shelf and zero-shelf bay assembly
También para Cisco ONS 15454: Manual de instrucciones de instalación (22 páginas), Instale (32 páginas), Desembalaje e instalación (42 páginas), Desembalaje e instalación (40 páginas)

Imprimir página

NTP-A5 Install the EIAs

Onsite/Remote

Security Level

Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband

Caution

cable into the ESD jack located on the lower-right outside edge of the shelf assembly.

EIAs are normally factory installed. Verify that the correct EIA is installed on the shelf assembly. If not,

Note

install the correct EIA.

Note

You do not need to power down the shelf before removing or installing an EIA. An in-service upgrade

of one EIA (A side or B side) is possible if all electrical traffic (DS-1, DS-3, DS3XM-6, and EC-1) is

being carried on the other side.

Complete the

Step 1

are locking connectors; the high-density BNC provides access to every port on every card.

Complete the

Step 2

up to 96 DS-3 circuits on each side of the ONS 15454.

Complete the

Step 3

every port on every card using more space and efficient cabling.

Complete the

Step 4

exclusive to DS-1 cables.

Complete the

Step 5

EIAs allow you to use high-density electrical cards. The UBIC-V EIAs provide SCSI connectors.

Complete the

Step 6

(horizontal) EIAs allow you to use high-density electrical cards. The UBIC-H EIAs provide SCSI

connectors.

Note

Continue with the

Step 7

Stop. You have completed this procedure.

Cisco ONS 15454 Procedure Guide, R5.0

1-8

Onsite

None

"DLP-A12 Install a BNC or High-Density BNC EIA" task on page 17-12

"DLP-A373 Install a MiniBNC EIA" task on page 20-57

"DLP-A13 Install an SMB EIA" task on page 17-15

"DLP-A14 Install the AMP Champ EIA" task on page 17-16

"DLP-A190 Install a UBIC-V EIA" task on page 18-61

"DLP-A399 Install a UBIC-H EIA" task on page 20-97

To attach cables to the EIAs, see the

Backplane" procedure on page

"NTP-A6 Install the Power and Ground" procedure on page

Chapter 1

"NTP-A9 Install the Electrical Card Cables on the

1-22.

Install the Shelf and Backplane Cable

as needed. BNCs

as needed. The MiniBNC allows

as needed. SMBs allow you to access

as needed. AMP Champs are

as needed. The UBIC-V (vertical)

as needed. The UBIC-H

1-9.

March 2005