Cisco UCS B460 M4 Nota de instalación y mantenimiento - Página 17

Navegue en línea o descargue pdf Nota de instalación y mantenimiento para Servidor Cisco UCS B460 M4. Cisco UCS B460 M4 50 páginas. Blade server
También para Cisco UCS B460 M4: Ficha de datos (7 páginas), Nota de instalación y mantenimiento (46 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (5 páginas)

Installing a Blade Server

This chapter contains the following sections:

•

If a UCS B460 M4 blade server is mixed with other full-width or half-width blades in the chassis, the UCS

B460 M4 blade servers must occupy the bottom two full-width slots in the chassis. The chassis should be

loaded with the largest server on the bottom, starting with a UCS B460 M4 blade server on the bottom,

followed by full-width blades above, and the half-width blades at the very top of the chassis.

Procedure

Step 1

If necessary, remove the slot divider from the chassis.

a) Simultaneously pull up on the left side catch and push down on the right side catch as shown in callout 1

of the following figure.

b) Pull the slot divider out of the chassis as shown in callout 2 of the following figure. Keep the slot divider

in case it is needed at another time.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

Installing a Blade Server in the Chassis, on page 9

Server Configuration, on page 11

Powering Off a Blade Server Using the Power Button, on page 11

Removing a Blade Server from the Chassis, on page 12

Server Troubleshooting, on page 12

C H A P T E R