Cisco VG202 Manual de configuración del software - Página 16
Navegue en línea o descargue pdf Manual de configuración del software para Pasarela Cisco VG202. Cisco VG202 50 páginas. Voice gateways
También para Cisco VG202: Manual de instalación del hardware (50 páginas), Manual (10 páginas), Manual de instalación del hardware (48 páginas), Manual de inicio rápido (19 páginas)
Imprimir página
Using the setup Command Facility
Using the setup Command Facility
The setup command facility is displayed in your PC terminal emulation program window.
To create a basic configuration for your Cisco VG, do the following:
•
•
If you make a mistake while using the setup command facility, you can exit and run the facility again.
Note
Press Ctrl-C, and enter setup at the enable mode prompt (
Configuring Global Parameters
Step 1
Plug in the external power supply.
Messages begin to appear in your terminal emulation program window.
The voice gateway will not enter setup mode during the initial configuration. During initial
Caution
configuration, the voice gateway boots up in auto-configuration. Using the setup command can only be
used to configure the voice gateway manually after initial configuration. Using the setup command
during the initial configuration will result in erasing the default config and must be avoided.
Caution
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause the Cisco VG to
power off and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following example.
System configuration has been modified. Save? [yes/no]: n
Proceed with reload? [confirm]
*Apr 21 14:23:38.051: %SYS-5-RELOAD: Reload requested
Command.
System Bootstrap, Version 12.4(20080415:092610)
[anyname-VG.V124_19_9_2_PIA9.14582.ios.sync 102], DEVELOPMENT SOFTWARE
Copyright (c) 1994-2008 by cisco Systems, Inc.
VG202 platform with 131072 Kbytes of main memory
Upgrade ROMMON initialized
program load complete, entry point: 0x80020000, size: 0x1437d40
Self decompressing the image:
##########################################################################################
##########################################################################################
################################# [OK]
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
2-2
Complete the steps in the
Complete the steps in the
Restricted Rights Legend
"Configuring Global Parameters" section on page
"Completing the Configuration" section on page
Chapter 2
Using the setup Command Facility
2-2.
2-5.
).
VG#
by console. Reload Reason: Reload
OL-16191-01