Epson ActionPrinter 5500 - ActionPrinter-5500 Impact Printer Boletín de asistencia sobre productos - Página 6
Navegue en línea o descargue pdf Boletín de asistencia sobre productos para Accesorios para impresoras Epson ActionPrinter 5500 - ActionPrinter-5500 Impact Printer. Epson ActionPrinter 5500 - ActionPrinter-5500 Impact Printer 14 páginas. Understanding and using escp/2 commands and syntax
También para Epson ActionPrinter 5500 - ActionPrinter-5500 Impact Printer: Manual de montaje (8 páginas)
Imprimir página
ESC (v m1 m2 n1 n2 is the command for advancing the print position vertically in
units where m1, m2, n1 and n2 are variables. The "unit" is usually 1/360 of an inch
unless defined otherwise by the "ESC ( U" command. Currently, the values for ml
and m2 MUST be m1=2 and m2=0.
To determine the values for n1 and n2 perform the following steps.
1.
Determine the desired vertical motion distance in inches.
2
Multiply the distance by 360.
3.
Divide the result by 256 using long division.
4.
The remainder in the quotient from step 3 is the value for n1.
5.
The whole number in the quotient from step 3 is the value for n2
EXAMPLE
1.
The desired distance is 1 inch.
2
1 x 3 6 0 = 3 6 0
3.
360 divided by 256=1 with a remainder of 104.
4.
n1=104
5.
n2=1
In the Basic programming language, the command would look like this.
This command, as listed in the line above, will feed the paper up 1 inch from the
current line. The current print column (horizontal position) IS NOT changed.
'Reverse" paper feed less than 1/2 inch can be performed with this command. To
accomplish "reverse" paper feeding requires the following steps.
1.
Determine the desired vertical motion dice in inches.
2
Multiply the distance by 360.
3.
Divide the result by 256 using long division.
4.
Subtract the remainder in the quotient computed in step 3 from 256.
5.
The result from step 4 is the value for n1.
6.
The value for n2 will always be 255.
PSB No: P-0082
Page: 6 of 14