Epson FX-880 - Impact Printer Información sobre el producto - Página 9

Navegue en línea o descargue pdf Información sobre el producto para Accesorios para impresoras Epson FX-880 - Impact Printer. Epson FX-880 - Impact Printer 17 páginas. Warranty statement
También para Epson FX-880 - Impact Printer: Hoja de especificaciones (2 páginas), Manual de instalación (10 páginas), Manual de consulta rápida (16 páginas), Manual (11 páginas), Especificación (2 páginas), Manual de información importante (8 páginas), Manual de montaje (8 páginas), Garantía limitada (1 páginas), Referencia rápida (12 páginas)

Imprimir página
Epson FX-880 - Impact Printer Información sobre el producto

Paper Thickness Lever Positions

The paper thickness lever is located under the printer cover.
You need to set the paper thickness lever for the type of paper
you are using, as shown in the table below.
Paper Type
Ordinary paper (single sheets or continuous paper)
Carbonless multi-part forms with:
2 parts (original + 1 copy)
3 parts (original + 2 copies)
4 parts (original + 3 copies)
5 parts (original + 4 copies)
6 parts (original + 5 copies)
Thin paper
Continuous paper with labels
Envelopes

Paper Handling

Loading Continuous Paper Onto a Push
Tractor
Front push tractor
Load paper printable side up.
Rear push tractor
1. If you are using the front push tractor, remove the front
Lever Position
0
1
2. Open both sprocket covers.
2
3
3. Fit the first four holes of the paper over the sprocket pins (as
4
5
–1 or 0
2
2 to 6
4. If you are using the front push tractor, reattach the front
5. Make sure the paper release lever is in the correct position.
6. Make sure that the paper guide is lying flat on the printer
Removing the Printed Document from a
Push Tractor
1. Make sure the
11/98
EPSON FX-880/FX-1180
Load paper printable side down.
cover.
If you are using the rear push tractor, remove the paper
guide.
shown above). Then close the sprocket covers.
Note:
Make sure the left and right sprockets are positioned properly
for your paper's width. If they are too far apart or there is any
slack in the paper, you need to move the sprockets.
cover.
If you are using the rear push tractor, reattach the paper
guide.
and the continuous paper support is in the upright position.
Tear Off/Bin
to press the
button.) When the
Tear Off/Bin
light is flashing, your paper is in the tear-off
Tear Off/Bin
position.
light is flashing. (You may need
EPSON FX-880/FX-1180
- 9