Whirlpool UTX5536AAB0 Instrucciones de instalación y manual de uso y mantenimiento - Página 10

Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Campana de ventilación Whirlpool UTX5536AAB0. Whirlpool UTX5536AAB0 28 páginas. 30" (76.2 cm) and 36" (91.4 cm) range hood installation instructions

Imprimir página

7. For non-vented (recirculating) installations:

•

Remove screws and rear support.

11. Replace the 2 lateral supports.

12. Replace filters. See the "Range Hood Care" section.

A. Rear support

Remove the blower mounting screws. Push up on the

blower to detach the blower from the mounting plate.

Remove the vent knockout from the front mounting plate.

A. Front mounting plate knockout

B. Blower mounting screws

C. Blower

Rotate the blower and attach to front mounting plate.

Install the blower mounting screws.

A. Front mounting plate

B. Blower mounting screws

•

Install charcoal filters. See the "Range Hood Care"

section.

8. Using 2 people, lift range hood into final position, feeding

electrical wire through wiring opening. Position the range

hood so that the large end of the keyhole slots are over the

screws. Then push the hood toward the wall so that the

screws are in the neck of the slots. Tighten mounting screws

to cabinet, making sure mounting screws are in narrow neck

of slots.

9. Check that damper, if used, rotates up and down freely.

10. Reinstall the rear support.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension

cord.

Failure to follow these instructions can result in death,

fire, or electrical

shock.

13. Plug 3-prong power cord into a grounded 3-prong outlet

located inside the cabinet above the range hood.

14. For Vented Installations

Only:

Connect ventwork to hood. Seal joints with clamps to make

secure and airtight.

1. Replace grease filters. See the "Range Hood Care" section.

2. Check the operation of the range hood fan and light. See

"Range Hood Use" section.

If range hood does not operate, check to see whether a

circuit breaker has tripped or a household fuse has blown.

Disconnect

power and check wiring connections.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the center of the range hood.

A. Halogen lamp housings

B. Grease filter handle

C. Blower and light controls

D. Grease filter