Whirlpool WVW75UC6DS Manual de uso y mantenimiento Instrucciones de instalación - Página 8

Navegue en línea o descargue pdf Manual de uso y mantenimiento Instrucciones de instalación para Campana de ventilación Whirlpool WVW75UC6DS. Whirlpool WVW75UC6DS 28 páginas. 36" (91.4 cm) island-mount canopy range hood
También para Whirlpool WVW75UC6DS: Instrucciones de instalación y manual de uso y mantenimiento (28 páginas), Instrucciones de instalación y manual de uso y mantenimiento (32 páginas)

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket

using (4) 4.2 x 8 mm screws.

2. Measure from the bottom of the air deflector to the bottom

of the hood outlet.

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over

the exhaust outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket

with the 4 assembly screws.

8. Seal connections with vent clamps.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet