Zanussi ZFT11100WA Manual del usuario - Página 11
Navegue en línea o descargue pdf Manual del usuario para Congelador Zanussi ZFT11100WA. Zanussi ZFT11100WA 16 páginas. Zanussi freezer user manual
También para Zanussi ZFT11100WA: Manual del usuario (16 páginas)
Imprimir página
Door reversibility
WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
CAUTION!
To carry out the following
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
1. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
2. Unscrew the left foot.
3. Remove the lower door hinge by
unscrewing the 2 retaining screws.
4. Remove the hinge pin from the bottom of
the door.
5. Slot the hinge pin into the hole in the hinge
plate.
6. Take the door off.
7. Refit the upper hinge pin into the opposite
location.
8. Fit the door in place on the hinge pin.
9. Slot the hinge pin into the hole in the hinge
plate and relocate the hinge assembly to
the opposite location and refit using the
retaining screws.
10. Refit the bottom hinge plate assembly on
the opposite side, taking care that the edge
of the door is parallel with the side of the
cabinet.
11. Remove and install the handle (if foreseen)
on the opposite side.
www.zanussi.com
CAUTION!
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
Electrical Connection
CAUTION!
Any electrical work required to install
this appliance should be carried out
by a qualified electrician or
competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any
liability should these safety
measures not be observed.
The wires in the mains lead are coloured in
accordance with the following code:
11