Alecto WS-4900 Manual del usuario - Página 14

Navegue en línea o descargue pdf Manual del usuario para Estación meteorológica Alecto WS-4900. Alecto WS-4900 20 páginas. Weather station with wireless outdoor sensor

Imprimir página

5. MAX-MIN ALERT

5.1 Introduction:

You may set an alert for the following measurements when a maximum or minimum value is being exceeded:

Indoor temperature

Indoor humidity

Outdoor temperature

Outdoor humidity

Rainfall

Wind speed

5.2 Hi-Lo limits setup:

1. Press the

AL' (whatever applies)

2. Use / to set the limit value

3. Briefly press the

4. Press the

automatically

5.3 Hi-Lo alert function setup:

1. Press the

AL' (whatever applies)

2. Briefly press the

5.4 Operation:

As soon as the set limit is exceeded, an alert will sound for up to 2 minutes while the concerned value starts

flashing. You may stop the alert sound by briefly pressing the ALARM/ SNOOZE button. The concerned

measurement value automatically stops flashing when it returns to within the set limit (or as soon as you

adjust the limit or switch off the alert function for this measurement).

6. ALARM CLOCK

6.1 Introduction:

You may program an alarm (wake-up) time in the WS-4900.

You may then also enable a frost alert: when the outdoor temperature falls below -3°C, the wake-up signal

will sound 30 minutes before the set wake-up time.

6.2 To set the alarm time:

1. Press and hold the

flashing

2. Use / to set the hours and then briefly press , the minute digits start flashing

3. Use / to set the minutes and then briefly press , the alarm time is now set

Attention: after setting the alarm time for the first time, this function is enabled directly.

6.3 To set the alarm function:

1. Press the

button once or several times to check the alarm or to switch it on/off

Only "AL" appears:

"AL" + " " appears:

"AL" + " " + " " appears: the frost alert is set

2. Release the

to the above description, remains visible

min/max alert

max alert (only the actual amount of rainfall as off 12:00am is considered)

max alert

button once or repeatedly until the desired display starts flashing followed by 'HI AL' or 'LO

button to save the value

button again to go to the next value or wait several seconds until the settings are closed

button once or repeatedly until the desired display starts flashing followed by 'HI AL' or 'LO

button to switch this alert on or off.

button at the rear of the weather station for 2 seconds until the hour digits start

the time being displayed is the set alarm time, but the alarm itself is switched

off

the alarm is switched on and the wake-up signal will sound at the set alarm

time

button, after several seconds the actual time is displayed and the alarm status, according