Aleko AR 900 Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Abrepuertas Aleko AR 900. Aleko AR 900 16 páginas. Sliding gate operator

How to learn or erase the remote

Learn the remote

Press and release the learn button, the REM LED light will be on,

then press the key in the remote twice in 2 seconds, the

REM LED light will flash for 4 seconds. Now the remote

has been learnt successfully.

Erase all the remote codes

Press and hold the learn button until the REM LED light is off. Now all remote codes have been erased.

How to use the remote to control the opener

Key A is used to operate the operator to work alternately (open-stop-close- stop-open).

When the Midway Mode function is enabled, Key B is used to achieve the Midway

Mode function (open the gate for the pre-setting time). When the Midway Mode

function is disabled, the operator works alternately (open-stop -close-stop-open) by

pressing Key B.

Have a multi-meter to check voltage and continuity. Use caution when checking high voltage terminals.

Symptom

The

remote

control

does not emit any

single

The opener doesn't

run. Power LED is

OFF

The opener doesn't

run. Power LED is ON

The gate starts but it is

immediately stop or

reverse

Check if the batteries are exhausted, replace them if necessary.

1. Make sure that the power cord is properly plugged into the mains outlet.

2. Check the fuse is blown in the control board; if necessary, identify the

reason for the failure and then replace a new one.

Make sure the photocell beam is not blocked if the photocell is used. Check

the terminal 16 should be shorted with terminal 17 by a jumper wire. Please

reset this jumper wire if it is loss.

1. The selected force is too small to move the gate. Turn the Potentiometer

clock-wise to increase the force.

2. Disconnect the gate from the gate operator and check that the gate slides

freely without any binding.

Possible Solution(s)

REV 12a