Aleko AR 900 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Abrepuertas Aleko AR 900. Aleko AR 900 16 páginas. Sliding gate operator

• Do not allow persons or children to remain in the automation operation area.

• Keep radio control or other control devices out of children's reach, in order to avoid unintentional

automation activation.

• The user must avoid any attempt to carry out work or repair on the automation system, and always request

the assistance of qualified personnel.

• Anything which is not expressly provided for in the present instructions is not allowed.

• Before installing the gate opener, check that all moving part as well as the sliding gate is in good

mechanical condition, correctly balanced and opens and closes properly.

• Save these instructions for future use.

Preparation for Installation

Before proceeding to your operator installation, check if your gate structure is in accordance with the current

standards, especially as follows:

The gate sliding track is linear and horizontal, and the wheels are suitable，the gate should be mounted and

moving freely. Check that the structure is sufficiently strong and rigid, and that its dimensions and weights

conform to those listed in the specifications table of this document. Make sure that the gate is plumb and

level. The fence posts must be mounted in concrete. The gate does not bind or drag on the ground.

• The gate manual operation can be carried out smoothly along its entire run, and there is no excessive side

slipping.

• The opening and closing gate stops are positioned.

WARNING: Remember that control devices are intended to facilitate gate operation, but can not

solve problems due to any defects or deficiency resulting from failure to carry out correct installation or

maintenance. Take the product out of its packing and inspect it for damage. Should it be damaged, contact

your dealer. Remember to dispose of its components (cardboard, polystyrene, nylon, etc.) according to the

current prescriptions.

Refer to the following Figures for gate installation.

In sake of safety, a positive stop must be mounted on the two end of ground track.