Aleko B4C Series Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Productos de fontanería Aleko B4C Series. Aleko B4C Series 16 páginas. Outdoor barrel sauna with/without canopy
Imprimir páginaTools :
Ⅰ. Base Assembly
(1)
Placement of base
Place the base shown in the figure, and adjust it in horizon by pads
(beneath the base).
(2)Bottom stave assembly
①
Take out the stave with drain hole and cable hole in the middle of the base, place
other stave in the same level with this one, and fix the end to the base with screws.
Note: Use stave with preset screw holes.
Firstly it must be fasten the stave to the base by screws at two ends.
W h e n u s i n g t h e p l a s t i c f e e t ,
no need to use the pad under the base
With Canopy
Without Canopy
(mm)
(mm)
200
150
200
150
200
150
200
150
200
150
①
Insert other stave to the edge of the base, gently tap them with a rubber hammer to
make them tightly packed and check to ensure the distance of front and back bases
from the edge of stave is 150mm. (shown in Figure 2
②
Ensure all cross slots are aligned and apply glass glue. (shown in Figure 2
③ Use screws to fasten the inserted staves onto the base. All the screws should be with
countersink processing. (Figure 2 ④)
③
warning: this step must be used after step4. Steel Strip Assembly.
②)
Center line
- 4 -
③)
Figure 2