3D Factories EASY 3D MAKER Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D 3D Factories EASY 3D MAKER. 3D Factories EASY 3D MAKER 14 páginas.

TURN OFF THE MACHINE CALIBRATION PROCEDURE IS PERFORMED IN PRINTER disconnected from electricity!

First put the paper on the print bed. Set screws so that the paper is just touching the nozzle. ATTENTION -

PAPER must move a little freely! Do this for 3 position and be used to check again. Crossing the nozzle into the

appropriate positions perform manually.

8.4 KONTROLA TISKOVÉ PLOCHY

Check the flatness of the print area and visually using a ruler or other flat surface.

If the print surface deflection, make sure that no point no higher than the lowest set point of nozzle. If

necessary, readjust the height of the nozzle or replace the print area.

VERSION: 1.9.2012

- 8 -