ARO 7744-10 Manual del usuario

Navegue en línea o descargue pdf Manual del usuario para Motor ARO 7744-10. ARO 7744-10 8 páginas. Power motor

Imprimir página

OPERATOR'S

MANUAL

Tool Products

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

50 SERIES POWER MOTOR

Released:

8-1-89

Revised: 10-6-95

Form:

3507-2

Models 7744-l 0 and 7744-l 5

WARNING

READ THIS MANUAL

CAREFULLY

BEFORE INSTALLING,

OPERATING

OR SERVICING

THIS EQUIPMENT.

FAILURE TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

Pneumatic tools should always be installed and used in accor-

dance with A.N.S.I. B186.1 "Safety Code For Portable Air Tools."

Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure

at the air inlet of the tool.

Disconnect air supply from tool before removing/installing

bit,

socket or device attached to tool or performing maintenance

procedures.

Keep hands, clothing and long hair away from rotating end of

tool.

Anticipate and be alert for sudden changes in motion during

start up and operation of any power tool.

Never exceed rated r.p.m. of tool.

Wear suitable eye and hearing protection while operating tool.

Tool shaft can continue to rotate briefly after throttle is re-

leased.

Do not lubricate tools with flammable orvolatile liquids such as

kerosene, diesel or jet fuel.

Do not remove any labels. Replace any damaged label.

Use only accessories

recommended

by ARO.

Repeated prolonged operator exposure to vibrations which may

be generated in the use of certain hand-held

tools may produce

Raynaud's

phenomenon,

commonly

referred to as Whitefinger

disease.

The phenomenon

produces

numbness

and burning

sensations in the hand and may cause circulation and nerve dam-

age as well as tissue necrosis.

Repetitive

users of hand-held

tools who experience

vibrations should closely monitor duration

of use and their physical condition.

The use of other than genuine ARO replacement

parts may

result in safety hazards, decreased tool performance

and in-

creased maintenance

and may invalidate all warranties.

ARO is not responsible

for customer modification of tools for

applications

on which ARO was not consulted.

Tool maintenance

and repair should be performed by autho-

rized, trained, competent

personnel.

Consult your nearest

ARO authorized servicenter.

It is the responsibility

of the employer to place the information

in this manual into the hands of the operator.

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand

Distribution

Center, White House, TN at PH: (615) 672-0321,

FAX: (615) 672-0801.

ARO Tool Products

Ingersoll-Rand

Company

1725 U.S. No. 1 North • P.O. Box 8000

Southern Pines, NC 2838843000

PRINTED

IN U.S.A.

Part of worldwide Ingersoll-Rand