3D Systems CubePro Manual - Página 10

Navegue en línea o descargue pdf Manual para Impresoras 3D 3D Systems CubePro. 3D Systems CubePro 11 páginas. Unjamming extruder
También para 3D Systems CubePro: Manual de instrucciones original (18 páginas), Manual de instrucciones original (12 páginas)

Imprimir página
3D Systems CubePro Manual
 Check jet's loom and position of thermocouple as shown:
 Install the jet back into the extruder drive. Level the jets and check the check Z gap as shown starting
on page 62 of the user guide. Disconnect head loom from the breakout board to avoid damaging the
components while levelling the jets. There will be a warning message on the screen. This can be
ignored for now. Replace the head loom connector when finished and reinstall the breakout board
using the two 2.5 mm Hex screws.
 Connect all looms back to sensor PCB and breakout board according to their markings.