3DLab GANG PRINT BEAT PZL p.11c Manual del usuario - Página 18
Navegue en línea o descargue pdf Manual del usuario para Juguete 3DLab GANG PRINT BEAT PZL p.11c. 3DLab GANG PRINT BEAT PZL p.11c 19 páginas. Polish fighter
Imprimir página
member of Group
WING ASSEMBLY
Right Wing Assembly: start by connecting the middle part (7) with the first wing part (18), then prepare the
parts 19-20.
Note: Before connecting the part (20) install the servo and run the servo cable through the prepared hole.
Aileron: Glue together the parts with the installed servo (19-20-21) into which you put the inner part of the
aileron (25) fitted with a 0.9mm-1.2mm axle made from a bowden wire or paper clips, then install the outer part
of the aileron (26) with the axle from each side and connect both parts of the ailerons so that the axle fits into
the wing openings.
Warning: Apply the glue carefully so that the aileron remains movable.
Right Wing Assembly Completion: Put on the part number (22) onto the aileron axle and glue part (22) with
the the wing part (21). The completed wing assembly cement to part number (13), then to the assembled wing
attach the strut mounts (29-30). Then attach wing struts (35) for fixing the wing to the fuselage.
17