Artistric Licence Rail-DALI-DMX Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Equipamiento industrial Artistric Licence Rail-DALI-DMX. Artistric Licence Rail-DALI-DMX 4 páginas.

Imprimir página

Troubleshooting

No power light

DALI controller is not

'seeing' Rail-DALI-DMX

DMX fixtures can only

be controlled by DALI

broadcast commands

The data light on

Rail-DALI-DMX is not

illuminated

Scene and Group

commands not working

DMX fixtures behaving

erratically

When I cycle power

to my DALI ballast,

it powers up at an

unexpected intensity

When I cycle power

to my DALI bus power

supply, the ballasts

go to unexpected

intensities

Artistic Licence

The Mould Making Workshop

Soby Mews

Bovey Tracey

TQ13 9JG

United Kingdom

Telephone

+44 (0) 20 8863 4515

Fax

+44 (0) 20 8426 0551

Email:

[email protected]

Web:

www.ArtisticLicence.com

Due to our policy of continuing product improvement specifications are subject to change without notice

1. Check that the DC power wires are connected to the correct

terminals and correct polarity.

2. Check power is switched on.

3. Disconnect all non-power cables. Switch off product and leave

for 20 minutes (this allows the thermal fuse to reset). Switch on.

If power light illuminates, it is likely that an external fault or wiring

error is causing the problem.

1. Product not powered on.

2. No DALI bus PSU present.

1. The Rail-DALI-DMX has not been commissioned. Use a DALI

tool such as DALI-Scope to achieve this.

1. Product not powered on.

2. No DALI bus PSU present.

3. DALI controller not connected.

1. Scene and Group commands are handled differently in Trigger

Mode. Try switching to Ballast mode (set DIP switch 6 OFF).

2. Scenes and Groups have not yet been programmed.

1. DMX cable not terminated at last fixture.

2. DMX cable is not suitable (must be data cable).

3. More than 32 DMX fixtures on the cable.

1. All DALI ballasts have a setting called 'Power On Level' which

defines their intensity after power cycle. The ballast will stay at

that intensity until Rail-DALI-DMX next refreshes it. Dali-Scope

can be used to both read and programme the Power On Level.

1. All DALI ballasts have a setting called 'System Failure Level'

which defines their intensity after a fault such as loss of DALI

bus power supply. The ballast will stay at that intensity until Rail-

DALI-DMX next refreshes it. Dali-Scope can be used to read the

ballast's System Failure Level. If power is not reinstated after 1s,

all the relevant DMX outputs will flash at full intensity.

Rail-DALI-DMX is CE compliant when installed

CE Compliance

in a shielded and earthed metal case

Customer support and knowledge base: