Artistry In Motion Big Shots Manual de funcionamiento y mantenimiento - Página 8
Navegue en línea o descargue pdf Manual de funcionamiento y mantenimiento para Equipo para DJ Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 páginas. Wireless transmitter and receiver
También para Artistry In Motion Big Shots: Instrucciones de carga y disparo (2 páginas)
Imprimir página2.1
THE ANTENNA
The RF signal is radiated by a quarter-wave flexible whip antenna which screws
onto the top end of the transmitter box.
operated without the antenna in place, as damage to the RF components
could result.
Be careful not to over tighten the antenna when screwing it on, as this could
cause its mating connector to rotate and break its internal connection. Rotation
could also occur, with the same result, when subsequent removal of an over
tightened antenna is attempted. The recommended way to install the antenna is
to grasp it by its small diameter upper part and rotate gently in a clockwise
direction until increased resistance is felt. It need not be tight to achieve a good
electrical connection. When removing the antenna for storage, observe the base
of the mating connector to ensure that it is not rotating. If the antenna is so tight
that rotation is occurring, grasp the hex base of the mating connector with long
nose pliers, and then unscrew the antenna.
2.2
The guarded toggle switch with two positions, "Safe" and "Armed". In the "Safe"
position no RF output occurs even if a button is pressed. In the "Armed" position
modulated RF output occurs continuously while a button is pressed. Whether
transmitting or not, a green warning indicator near the switch flashes whenever
the switch is in its "Armed" position and the battery voltage is above the low
battery detect threshold. Approximately 1 milliamp is drained continuously from
the battery while the transmitter is "Armed" and not transmitting. So this switch
should always be turned to the "Safe" position while the transmitter is not being
used. The key may only be removed from the switch in "Safe" position. Keys are
interchangeable, as all Big Shots® Wireless Transmitters are keyed the same.
THE "ARMED" INDICATOR
2.3
This green lamp, located at the "Armed" position of the toggle switch, warns the
user that transmission will occur when a button is pressed, and that battery drain
is occurring. It also verifies that battery voltage is adequate to transmit a signal
over the specified range.
When the transmitter is turned on (transmitter "Armed") with the toggle switch,
the battery status is indicated by the flashing of the green lamp. It is of
sufficiently high intensity to be visible in direct sunlight and will flash
intermittently in bursts of one, two, or three flashes at a time if the battery has
enough capacity to power the transmitter. If no flashing occurs, the battery must
be replaced before the transmitter can be used reliably. Three flashes per burst
indicate that the battery has full capacity; two flashes indicate that its capacity is
beginning to diminish, and one flash indicates that it is near the end of its useful
lifetime in which case it should be replaced immediately after the current use.
Artistry In Motion, Inc.
Tel: 818.994.7388
Ver 08/20
Such operation will void the warranty.
THE SAFETY LOCKING SWITCH
Fax: 818.994.7688
The transmitter should never be
19411 Londelius Street, Northridge, CA 91324
Website:www.artistryinmotion.com
Page 8