Alvin XII-3-XB Instrucciones de montaje

Navegue en línea o descargue pdf Instrucciones de montaje para Mobiliario interior Alvin XII-3-XB. Alvin XII-3-XB 2 páginas. Professional table

Tools Required:

Phillips screwdriver, ruler, and drill with 1/16" bit (tools not included)

Parts Included:

1pc Leg Frame

Assembled table

To Assemble:

Unpack parts and inspect to confirm that all are present.

Unfold leg frame (A). Insert rear extension tubes (C) into

back tubes of leg frame with mounting brackets facing out.

Slide tubes in as far as they will go and then loosely hand-

tighten height adjustment knobs (F). See Figure 1.

Insert front extension tubes (D) into front tubes of leg

frame with the curved black caps facing front and back. See

Figures 1 & 2. Set each tube at a height of approximately 4"

and then loosely hand-tighten height adjustment knobs.

Place tabletop (B) with preferred side down on a

carpeted or protected floor to prevent scratching. Turn the

assembled base frame upside down and place on tabletop

with front guide tracks (G) placed (but not screwed in yet)

under the front extension tubes. See Figure 3.

Professional Table

Assembly Instructions

1pc Tabletop

(Shipped in

separate box)

2pcs Rear Extension Tubes

2pcs Front Extension Tubes

4pcs Height

Adjustment Knobs

2pcs Front Guide Tracks

Figure 1

Figure 3

Page 1 of 2

MODEL X-3-XB, MODEL X-4-XB,

MODEL XI-3-XB, MODEL XI-4-XB,

MODEL XII-3-XB, MODEL XII-4-XB

2pcs Floor Glides

(Already installed

into legs)

12pcs 1/2"

Wood Screws

Figure 2