Ashly PE-800 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Ashly PE-800. Ashly PE-800 13 páginas. Pe series high performance professional power amplifiers
También para Ashly PE-800: Notas técnicas y especificaciones (2 páginas), Manual de instrucciones (13 páginas), Manual de instalación y uso (2 páginas), Hoja de especificaciones (2 páginas)

Page - 10

Operator Manual – PE Series Amplifiers

Introduction - 2

Measurements

The PE Series - 3

Physical Description - 4

The following graphs are actual measurements from PE-Series amplifiers during typical use.

Installation – 5

Operation – 7

Troubleshooting - 8

Spec Table - 9

Measurements - 10

Dimensions - 11

Gain vs. frequency, Ch1, Ch2 - (typical performance)

Gain vs. frequency / positions of HPF, Ch1, Ch2

Warranty - 12

Phase vs. frequency, Ch1, Ch2

Phase vs. frequency / positions of HPF-Switch, Ch1, Ch2

Output impedance vs. frequency @ 1 Amp RMS injected current

THD+N @ 1 kHz, 8 Ω load vs. input voltage, Ch1, Ch2

(Ch1, Ch2) equivalent 11 mΩ + 2,1 µH

Damping factor into 8 Ω, Ch1, Ch2 equation: damping factor = loaded

THD+N vs. frequency (BW 22 kHz),

impedance / amplifier output impedance

10 dB below clip, 8Ω, Ch1, Ch2

CCIF difference frequency method (10,5 kHz and 11,5 kHz) vs. input

SMPTE intermodulation distortion (60 Hz and 7 kHz)

level @ 8 Ω, Ch1, Ch2

@ 8 Ω vs. input level, Ch1, Ch2

Common mode rejection ratio (Ch1, Ch2)

Channel separation vs. frequency

@ 10 W / 8 Ω (Ch1 => Ch2, Ch2 => Ch1)