Ashly TRA-2150 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Ashly TRA-2150. Ashly TRA-2150 12 páginas. Tra-series
También para Ashly TRA-2150: Notas técnicas y especificaciones (2 páginas), Especificaciones (2 páginas), Manual de instrucciones (12 páginas), Especificaciones (2 páginas), Manual de instrucciones (13 páginas)

Page - 6

Important Safety

Instructions – 2

Introduction - 3

TRA-Series amplifiers are designed for use in both fixed and mobile sound systems. Each

The TRA Series - 4

amplifier is shipped (unless otherwise specified) with the following factory settings:

Physical Description - 5

Front Panel

Front panel:

Rear Panel

On/Off Switch = Off

Installation – 6

Attenuators =

Requirements

Typical Applications

Connectors & Polarity

Before connecting to mains power, make sure that the switches are set to the configuration

needed for your particular application. Always switch the amplifier off before making any

Operation - 8

changes to the settings. Failure to do so could result in damage to the unit or other components

Troubleshooting - 9

in your system. CAUTION: When mounting or connecting the amplifier, always disconnect it

Spec Table - 10

from the mains. Use four screws and washers when mounting the amplifier to the front rack

Dimensions - 11

rails. Rear support is also recommended, especially for mobile or touring use. To reduce the

risk of fire or electric shock, do not expose this apparatus to rain or moisture.

Warranty - 12

Requirements

TRA-Series amplifiers have specific physical, electrical and signal requirements for proper

operation. These requirements will vary depending on your specific application, setup, and

the settings on the amplifier. When setting up and testing your system, please take special

care to double check all connections and settings. Please refer to the specifications section

of this manual for specific input, output and other figures.

Operator Manual – TRA Series Amplifiers

Rear panel:

High Pass Filter(s) = Off

Gain Selector = +26 dB