Air ATOS VX Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Air ATOS VX. Air ATOS VX 12 pages.

Imprimer la page

11.)

Wing tip edge pipe with rib 9 up to Notice push

in. Open in addition the Klettverschluss, at sail

rear edge, between rib 8 and 9 and sails so far

back-invert that the cross-beam end is free.

Importantly: Sail or cross-beam can be

damaged, if the wing tip edge is not put in up to

the notice. The carbon reinforcement concisely

to the rib 9 on the wing tip edge pipe Ankletten.

12.)

Wing tip edge staff up to the notice put

in. Open in addition Klettverschluss

between rib 9 and wing tip edge tension

adjuster. The slot at the end of the wing

tip edge staff, must stand in

approximately parallel to the sail rear

edge, in order to be able to hang up the

wing tip edge tension adjuster here.

13.)

Wing tip edge stretch.

14.)

Ribs of the wing tip edge beginning stretch. R9, R8 then the individual Zwischenrippe, R7...

after stretching rib 6 the spoiler by means of rubber line with the spoiler lever connect.(Tap:

Klettverschluss at the sail rear edge only as far as necessarily open and afterwards again

close.)

Attention: The rib clamping lever completely into the associated slot insert and only then

with a hand only turn with thumbs and index fingers to a complete stop. Not with the

second hand on the gilled pipe pull or press (danger of fracture!). One should have

problems when stretching can with the second hand when stretching through pressures on

the rib end be helped. (Still more easily this goes with rib clamping fixture, which is put on

for extension on the rib tension adjuster. This development aid is optionally available). The

rib tension adjuster must engage noticeably and may not also not too with difficulty go. If

necessary, can be solved for adjusting the tension of the Klettverschluss and again be

angeklettet with appropriate disalignment. Placing behind is particularly after

approximately. the first 10 flying hours or in extreme weather (damp and cold or drying and

hot) necessarily. Particularly thoroughly the rib No. should. 6, at which the spoiler is linked,

in this connection to be examined. The ribs 7 and 8 should be as firmly as possible strained

thereby the sail also in the high-speed flight well lie.

15.)

Spoiler with safeguard

rubber fasten to the

spoiler lever

16.)

That curve-fold-hurry with the pins at the curving flaps hang up.

17.)

Front Unterverspannung hang up and secure. Importantly: The steering rope hang up only if

the sail at rib is already strained 6. The spoiler lever could be expenditure-steered

otherwise with course at the steering rope and be damaged thus cross-beam or sail.

18.)

Fold-hurry into the clamp at the basis contrive.

19.)

Lower zipper close.

20.)

Nose bullet ankletten. Importantly: Klett must be concise with counterpart.