Amerihome LICBKIT20 Instructions - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Amerihome LICBKIT20. Amerihome LICBKIT20 4 pages. 20v lithium ion battery and charger
Liquids may leak from the rechargeable battery in the event of damage, improper use or over-ageing. This can cause skin irritation or burns. Use
•
suitable protective gloves, if this is the case. Avoid direct contact with the skin; do not allow liquid to get in the eyes. In case of accidental contact,
rinse the affected skin areas with a lot of clear, lukewarm water; do the same for eye contact. In case of eye contact (or stronger irritation of the
skin), consult a physician.
Liquids leaking from batteries are chemically very aggressive. Objects or surfaces coming into contact with these liquids could be severely
•
damaged. Thus, store batteries/rechargeable batteries in a suitable location.
The rechargeable battery must not get damp or wet; shield the rechargeable battery from cold, heat and sunlight. Failure to observe this can not
•
only reduce the operating life of the rechargeable battery, but can also result in damage. In extreme cases, there is also a risk of explosion!
Do not place any objects on the rechargeable battery.
•
d)
Charging
Use only the charger that is associated with the system for charging. Use of chargers other than that recommended by us poses is a significant
•
risk of fire or explosion of the batteries!
Before charging the rechargeable battery, observe the operating instructions of the charger.
•
Never leave the battery to charge unsupervised.
•
The rechargeable battery gets warm during the charging process, even at high discharge currents. For this reason, it is necessary to ensure
•
sufficient ventilation.
The rechargeable battery fits only in one direction into the charger or battery- operated power tools. Never use force to insert the rechargeable
•
battery.
Do not charge the rechargeable battery while it is still hot (e.g. after operation in a power tool). Allow the battery to cool down to room temperature
•
before attempting to recharge it.
Never charge a damaged, leaking or deformed rechargeable battery. This may cause a fire or explosion! Discontinue use immediately and
•
dispose in an environmentally-friendly manner of a rechargeable battery that has become unusable in this way.
An unused li-ion rechargeable retains its energy normally for several months; however, total discharge will cause permanent damage and result in
•
its being unusable.
If the rechargeable battery is to be stored for a long period of time, please note:
Remove the rechargeable battery from the power tool.
o
Select a dry and cool place for storage.
o
The rechargeable battery should not be fully charged for longer periods of storage; an ideal charge status is approximately between
o
50% and 75%.
Check the charge status on a regular basis and charge the rechargeable battery if necessary.
o
Please consult the operating instructions of the charger.
Removing/inserting the rechargeable battery
In order to remove the rechargeable battery from a power tool, press and hold the unlock button on the rechargeable battery and then remove the
•
rechargeable battery from the power tool. Do not use any force.
To insert the rechargeable battery in a power tool, simply slide the battery with correct orientation into the corresponding battery intake of the
•
power tool until it engages. Do not use any force.
The charger does not have an engaging function, the rechargeable battery can simply be pulled out of the charger.
Control button and LED indicators - Important!
Before you use the control button, cease operation with the power tool. Wait until the drive of the power tool completely stops and no tool parts are
turning. On one side of the rechargeable battery, there is a control button and 3 LEDs. Press the control button to show the battery capacity.
The more LEDs that light, the greater the rechargeable battery's charge level. If none of the LEDs light up, this means that the rechargeable battery is
empty and has to be recharged immediately.
Care and Cleaning
Remove the rechargeable battery before cleaning from the power tool or the charging device.
•
A dry, soft and clean cloth is sufficient for cleaning the exterior.
•
Dust can be easily removed using a clean, long-haired brush and a vacuum cleaner.
•
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may damage the housing or cause the product to
•
malfunction.
Disposal
Electronic devices are recyclable waste and should not be disposed of in the household waste. At the end of its service life, dispose of the product
according to the relevant statutory regulations.
BATTERY CHARGER INSTRUCTION
ITEM # LICBKIT20 Instructions
Product overview
1. Unlock button
2. Release latch (locks the rechargeable battery in the power tool; retracts into rechargeable battery when unlock
button is pressed)
3. Control button
4. LEDs for monitoring the charge status
Charging
3