AMERITRON AL-811HD Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} AMERITRON AL-811HD. AMERITRON AL-811HD 16 pages. Hf power linear amplifier

Imprimer la page

PLEASE READ THIS MANUAL BEFORE ATTEMPTING TO OPERATE EQUIPMENT!!

1. Carefully lift the amplifier by the bottom cabinet edge out of the shipping carton. Place the

amplifier on a firm, level surface and carefully inspect it for shipping damage. Contact the

shipper immediately if any damage exists. Save the carton and packing material for possible

shipping in the future.

2. Remove the twelve screws holding the cover on with a number 2 phillips screwdriver.

Carefully lift the cover off the amplifier. Save the screws to rescuer the cover. Note that the

AL811HD is shipped with the fuses and fuse caps inside the amplifier.

3. Locate the fuse pack with the two 12 ampere fuses and fuse caps. If additional screws are

needed, they will be in the fuse pack also. NOTE: Fuses supplied are for 120/110/100V

operation (Models AL-811HD/HDY).

240/230/220V operation, you must use 8 ampere fuses. The AL-811HDX export model is

pre-wired for 240V operation and is supplied with 8 ampere fuses.

4. Remove the foam packing material (around the tubes) that secures the 572B tubes during

transit. Carefully unwrap the tubes. Do not dislodge or break the shaft that is connected to

the rear input bandswitch wafer.

5. To install the tubes in the sockets, be sure the large diameter pins line up with the two large

diameter holes in each socket. Do NOT rock or twist the tubes excessively during the

installation. If the tubes are already installed, check them for proper seating. If necessary,

press the tubes down into their sockets with gentle force. Do not rock or twist the tubes

excessively. Also, check that the anode caps are secure and that they did not come loose

during the unwrapping process.

6. The white ceramic anode connector will have to be removed from the top metal cap of each

tube if it ever becomes necessary to remove the tubes from the amplifier. This can be a

difficult procedure because the high clamping force of the internal springs in the anode

connector may hold it to the cap very tightly. The tube will break if direct upward or rocking

pressure is applied in an attempt to remove the connector. The safest way to remove the

ceramic connector is to lift the tube out of its socket. A twisting or spinning pulling motion

can then be applied while holding the ceramic connector firmly until the tube and connector

are separated. Repeat the procedure with each tube.

7. Install the cover with the vent holes to the left (near the tubes) by installing the back screws

first. Install all the screws loosely and tighten them only after all the screws are in place.

8. Install the fuses and fuse caps on the back of the unit. Read the manual to become familiar

with the operation of the amplifier.

UNPACKING INSTRUCTIONS

If you are rewiring the AL-811HD for