Air King AK5000 Instructions d'installation, d'utilisation et d'entretien - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Air King AK5000. Air King AK5000 14 pages. Flow-through furnace humidifier
Également pour Air King AK5000 : Manuel de garantie, d'entretien et de dépannage (14 pages), Manuel d'installation, de garantie, d'entretien et de dépannage (14 pages)

Imprimer la page

1. Humidifier Operation

• ELECTRICAL WIRING, WATER SUPPLY, AND DRAIN TUBE

MUST NOT KINK OR COME INTO CONTACT WITH SHARP

EDGES OR HOT SURFACES.

• IF REPLACING AN EXISTING FURNACE HUMIDIFIER, WE

RECOMMEND YOU REPLACE ALL COMPONENTS TO

ENSURE PROPER HUMIDIFIER OPERATION.

• THE INSTALLATION OF THIS PRODUCT MUST COMPLY

WITH NATIONAL AND LOCAL ELECTRICAL, PLUMBING,

BUILDING, AND MECHANICAL CODES.

REQUIRED TOOLS

• Safety glasses

• Work gloves

• Electric or cordless drill

• Drill bits (

• Tin snips

• Full size Philips or Roberstons screw driver

• Short handle Philips or Roberstons screw driver

• Adjustable wrench

• Utility knife

• Pliers

• Level

• Tape

• Measuring tape or ruler

• Medium-grit sand paper

• Pencil

SELECTION OF LOCATION

TO MOUNT THE HUMIDIFIER

All bypass type furnace-mount humidifiers rely on the pressure

difference which exists between the supply duct (hot air) and the

return duct (cold air) to create an air flow through the

humidifier's evaporator pad. The air will ALWAYS flow from hot

(high pressure) to cold (low pressure).

•INSTALLATION TIP: Before starting fully plan out the

installation. Check for the locations of the humidifier,

bypass collar & damper, and the humidistat and

associated sensors. Plan the length and type of ducting

required, the water supply, the water drain, the electrical

wiring, and a constant 120 volt outlet to plug in the

transformer. This will ensure your installation goes as

easy and quickly as possible

1. The humidifier body and bypass tube are installed at eye level,

easily accessible for installation and routine maintenance.

2. The space between the humidifier body and bypass tube are

INSTALLATION AND OPERATING INSTRUCTIONS:

Furnace Humidifier

no more than 30" to ensure maximum air flow through the

humidifier.

3. The supplied flex bypass tube is cut to the proper length and

pulled tight to ensure maximum air flow.

4. The humidistat is located a minimum of 6" upstream of the

humidifier, where moist air will enter the return duct.

5. The bypass damper is fully open.

6. The humidifier is mounted level on the duct.

7. There is nothing inside the duct behind the bypass collar and

damper or the humidifier body.

8. The humidifier body and the bypass collar and damper are level.

IDEAL INSTALLATION

Figure 1

SUPPLY DUCT

HOT AIR

Damper fully open

Not all installations will be as shown above – in cases where:

• The bypass duct

required is more than

the supplied 30"

• The bypass collar and

damper must be

installed above or

below the humidifier

• The bypass collar and

damper must be

installed

perpendicular to the

humidifier

Use hard metal duct and

hard metal elbows. This will

minimize the amount of air-

flow restriction.

Furnace Humidifier

RETURN DUCT

COLD AIR

8" wide duct minimum

No more

than 30"

Bypass collar and

unit level

Bypass tube pulled

tight and cut to length

SNAP OFF

AND SAVE

Figure 2