Amprobe RTD-10 Manuel de l'utilisateur - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Amprobe RTD-10. Amprobe RTD-10 19 pages. Rtd

"HOLD" key again to resume recording. (Previously

recorded read are not erased).

"SET" Mode (Relative value set, Time set and Hi/

Lo Limits value set)

1. Press the "SET" key to enter relative values SET

mode (Press "ENTER" key to skip setting relative

value). "= = = =.=" is displayed on the main display.

The relative value is entered via overlay numbers,

press overlay "ENTER" key to store the relative

value, and advance to elapsed time set mode.

2. Elapsed time set mode, (Press "ENTER" key to skip

Elapsed time set mode) "=.= = = : = =" is displayed

in second and third display. Time (hours, minutes,

seconds) value is entered via overlay numbers, press

overlay "ENTER" key to store time value. Elapsed

time starts from set time value.

3. Hi Limit value set mode, (Press "ENTER" key to skip

Hi Limit value set mode), "= = = =.=" is displayed in

main display, Hi Limit value is entered via overlay

numbers, then press "ENTER" key to store the Hi

Limit value. "= = = =.=" is displayed in main display,

Lo Limit value is entered via overlay numbers, then

press overlay "ENTER" key to store the Lo Limit value

and exit SET mode.

4. When the thermometer is turned on it uses the

relative value and Hi/Lo Limits values that were

entered when thermometer was last in use.

T1 T2 / T1-T2 second display Input Selection

The input selection indicates which input is selected for

second display; T1 probe, T2 probe or the difference

between the two probes (T1-T2), when the thermometer

is turned on, it is set to T2 input can select alternate of

probe by second display Pt385/Pt3926/Pt3916 key switch.