Electrolux 95G Livret d'instructions - Page 17

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Electrolux 95G. Electrolux 95G 20 pages. Gas and mixed fuel cookers
Également pour Electrolux 95G : Livret d'instructions (20 pages), Manuel d'instruction (24 pages), Livret d'instructions (20 pages)

Imprimer la page

Replacement of oven burner nozzle

To replace the oven nozzle, follow this procedure:

remove the bottom of the oven;

unscrew screw 1 (Fig. 25) and take the oven burner out;

with a socket spanner 7 unscrew and remove the nozzle, situated

in the bottom of the oven, and replace it with the proper one (see

Technical data);

reassemble the burner following the same procedure backwards.

Replacement of grill burner nozzle

To replace the grill burner nozzle, act as follows:

a) remove the screws, marked with letter "A" in Fig. 26;

b) take the grill burner out;

c) with a socket spanner n. 7, unscrew and remove the nozzle,

situated in the oven top, and replace it with the proper one (see

Technical data);

d) undo the fixing screw of the metal ring of primary air adjustment

and adjust the relevant opening (see diagram);

e) reassemble the burner following the same procedure backwards.

Minimum level adjustment of oven burner

After setting the oven on maximum temperature with closed door

for about 10 minutes, turn the knob of the thermostat on MIN.,

remove the knob and:

— in case of conversion from natural gas to liquid gas, tightly

screw the by-pass pin of thermostat;

— in case of conversion from liquid gas to natural gas, unscrew

about one-half turn by-pass pin, until a regular small flame is

reached.

— in case of conversion from liquid gas to town gas, unscrew

about one turn by-pass pin, until a regular small flame is reached.

— in case of conversion from natural gas to town gas, unscrew

about one turn by-pass pin, until a regular small flame is reached.

The oven burner does not need any primary air regulation.

Adjustment of thermostat by-pass pin

To reach the thermostat by-pass pin, act as follows:

take out the knobs;

remove the front panel;

adjust the by-pass pin with a thin screwdriver, as shown in Fig. 27;

finally check that turning quickly the tap from maximum position

to minimum position, the flame does not go out;

reassemble the front panel and the knobs.

WARNING

If the pressure of gas used is different (or variable) from that

foreseen, an appropriate pressure regulator must be installed on

the entry tube. in case of pressure regulators for GPL are used,

these must conform to regulation.

Replacement of the gas adjustement plate

After the gas adjustment operation of the new appliance to the

new type of gas has been completed, please replace the gas

adjustment plate (located next to the connection pipe) with the

gas adjustment plate that relates to the new type of gas being

used. The gas adjustment plate can be found in the envelope

containing the documents (e.g. the guarantee etc.).

Insertion possibility

In case of insertion of the appliance between kitchen units, the

dimensions to be respected are shown in Fig. 28.

When the kitchen is installed according to class 2, sub-class

1 (i.e. built-in) for the gas connection use only flexible metallic

tubes conforming to rules in force.

Fig. 26

Natural gas adjustment: full opening width

Liquid gas adjustment: opening 10 mm wide

Fig. 27

100

Fig. 28

1 7