Bosch DISHWASHER Manuel d'instructions d'installation - Page 15

Imprimer la page

Bosch DISHWASHER Manuel d'instructions d'installation

Strain Relief

(not supplied)

Figure 28

Strain Relief Plate

Figure 29

Electrical Connection

ELECTRICAL CONNECTION

Strain

Relief

Plate

To avoid electrical shock, do not work on an

energized circuit. Doing so could result in serious

injury or death. Only qualified electricians should

perform electrical work. Do not attempt any work

on the dishwasher electric supply circuit until you

are certain the circuit is de-energized.

To avoid a fire hazard, make sure electrical work

is properly installed. Only qualified electricians

should perform electrical work.

Grounding Instructions

The dishwasher must be properly grounded before

operating. This appliance must be connected to a

grounded metal permanent wiring system, or an

equipment grounding conductor must be run with the

circuit conductors and connected to the equipment

grounding terminal or lead on the dishwasher. Make sure

that the dishwasher is connected to a suitable ground in

compliance with all local codes or, in the absence of a

Outer Wire

local code, with the NATIONAL ELECTRICAL CODE in

Casing

the United States or the CANADIAN ELECTRIC CODE

C22.1-latest edition in Canada as well as any provincial/

state or municipal or local codes that apply.

1 Retrieve the strain relief plate, and install a strain relief

(not supplied) into the opening on the strain relief plate.

NOTE: Orient the strain relief as shown in Figure 28.

2 Pass the electrical supply cable through the strain

relief, as shown in Figure 29. Make sure the outer wire

casing extends about 1/2" (13mm) through the strain

relief.

3 Tighten the strain relief screws.

4 Slide the strain relief plate into the junction box, and

secure it to the junction box with the supplied screw.

WARNING

Electrical Shock Hazard

WARNING

Fire Hazard