Advanced Control HomePro ZDW103 Manuel d'instructions - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Advanced Control HomePro ZDW103. Advanced Control HomePro ZDW103 7 pages. Wall mounted 3-way dimmer receiver

Imprimer la page

Enable Shade Control Group 2

• Parameter 14

• Length: 1 Byte

• Valid Values: 0 or 1 (default 0)

The ZDW103 can control shade control devices via its group 2 if this configuration parameter is set to 1.

Enable Shade Control Group 3

• Parameter 15

• Length: 1 Byte

• Valid Values: 0 or 1 (default 0)

The ZDW103 can control shade control devices via its group 3 if this configuration parameter is set to 1.

LED Transmission Indication

•

Parameter 19

•

Length: 1 Byte

•

Valid Values = 0 , 1, 2 (default 2)

The ZDW103 will flicker its LED when it is transmitting to any of its 4 groups. This flickering can be set to not

flicker at all (set to 0), to flicker the entire time it is transmitting (set to 1), or to flicker for only 1 second when it

begins transmitting (set to 2). By default, the ZDW103 is set to flicker for only 1 second.

Each Configuration Parameter can be set to its default setting by setting the default bit in the Configuration Set

command. See your controller's instructions on how to do this (and if it supports it).

All Configuration commands will be reset to their default state when the ZDW103 is reset from the Z-Wave system.

Powerlevel

The ZDW103 supports the Powerlevel command.

The Powerlevel command allows controllers to set and get the RF transmit power level of a node and test specific

links between nodes with specific RF transmit power. Refer to your controller's instructions, if it supports this

command, for more information. This command is typically used by professional installer

SUC Support

There must be a Static Update Controller in your Z-Wave system for this feature to work. A Static Controller is

one that is not moved after addition to the network. The Static Controller can act as a gateway in the system, since

other nodes always know its position. The "always listening" advantage of the Static Controller is that other nodes

can transmit information frames to it whenever needed.

You can assign an "SUC Route" to the ZDW103. Refer to your Controller's instructions on how to do this (if it

supports it). Assigning an SUC Route to the ZDW103 allows it to request an update of the Z-Wave devices that

are between it and the Z-Wave device to which it was trying to transmit. The ZDW103 will only request an update

when a transmission fails.

SPECIFICATIONS

Power

Signal (Frequency)

Range

INTEROPERABILITY WITH Z-WAVE™ DEVICES

A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different

manufacturers. The ZDW103 can be incorporated into existing Z-Wave™ networks.

The top or bottom of the paddle switch on the face of the ZDW103 can be used to carry out inclusion, association,

or exclusion.

ZDW103 Instructions, Release 1.1

P/D 102406

120 VAC, 60 Hz

908.42 MHz

Up to 100 feet line of sight between the Controller and /or the

closest HomePro Receiver Module

0703-01

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.