Electrolux EW 1042 S Livret d'instructions - Page 19

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Electrolux EW 1042 S. Electrolux EW 1042 S 22 pages.

4. Water inlet filter

If you notice that the machine is taking longer to

fill, check that the filter in the water inlet hose is

not blocked.

Turn off the water tap.

Unscrew the hose from the tap.

Clean the filter with a stiff brush.

Screw the hose back onto the tap.

If the water is not discharged (outlet pump is

blocked, filter or outlet hose are clogged),

proceed as follows to empty out the machine:

pull out the plug from the power socket;

close the water tap;

if necessary, wait until the water has cooled

down;

place a bowl on the floor;

put the outlet hose end into the bowl and let

the water come out.

Should it not be possible to have access to the

outlet hose because, for example, the appliance

is built in the kitchen furniture, slightly loosen the

outlet filter after placing a bowl on the floor, to let

the water come out slowly.

At the end screw the filter again.

If the machine is installed in a place where the

temperature could drop below 0°C, proceed as

follows:

Close the water tap and unscrew the water

inlet hose from the tap.

Place the end of the outlet hose and that of

the inlet hose in a bowl placed on the floor.

Select programme L (draining) and run it until

the machine stops.

Depress the ON/OFF button again to switch

the machine off.

Screw the water inlet hose back on and put

the outlet hose back in its place.

By doing this, any water remaining in the

machine is removed, avoiding the formation of

ice and, consequently, breakage of the affected

parts.

When you use the machine again, make sure

that the ambient temperature is above 0°C.