Anchor Navi-Trac Lite Manuel d'instructions d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Anchor Navi-Trac Lite. Anchor Navi-Trac Lite 20 pages. Frame tent 30' wide system

Imprimer la page

ASSEMBLING THE CROSS BEAM

Begin the hip end installation by assembling the cross-beam sec-

tion of the hip end framing with the eave bars connected, (see

fig.4)

The following illustrations show details of each step to complete

this assembly phase. Notice that the uprights (legs) are not

installed at this time. They will be added with the help of a tent

jack after the hip end upper frame is completely assembled.

Appropriate pins are attached to the weldments. The long pins

pin vertically through the aluminum extrusions. The short pins

pin horizontally through the aluminum extrusions.

After completing each step on this page, the hip end frame should

resemble the drawing to the right.

PARTS LAYOUT

Begin by laying out the parts neatly

in their approximate location, as if the

frame were collapsed onto the ground.

INSTALLING THE RIDGE BRACE

R-30

Adjust the spread of the cross-beam so that the

ridge brace can be installed and pinned at the top

hole above the Rafter-Purlin brackets (outlined in

white).

E-15 on opposite side

RAFTER W/ Hook (RH-30)

Install the Rafter w/ Hook (RH-30) to the center

bracket of the Ridge Weldment (RW), and let it

lay on the ground until the cross-beam is pivoted.

ASSEMBLING THE HIP CROSS BEAM

H-30

Install an Eave Weldment (EW) to the lower

(tapered) ends of each Rafter (R-30). Insert

the short pin provided thru the rafter (side-

to-side) to secure the connection.

R-30

PURLIN

BRACKET

LINER PULL ROPE

CLOSE-UP OF RIDGE BRACE

Close up of the Rafter/ Ridge Brace connec-

tion. Note the matching holes on the brace and

the rafter are both circeld in white. (Also, notice

the liner rope and pulley attached at this same

pin location at this time (only if a liner is to be

installed later).

Close-up of the Rafter w/ Hook (RH-30)

being connected to the Ridge Weldment

(RW). (Notice the pivoting latch of the

Rafter Hook.)

END RAFTER

W/ HO0K

CROSS BEAM

RAFTERS

JOINING CROSS BEAM AT RIDGE

Slide the top (squared) ends of

each Rafter (R-30) onto the Ridge

Weldment (RW) and secure with the

short pins provided on the weldment.

At the Eave Weldment on both sides of

the cross-beam, slide eave bars onto the

weldment and secure with the long pins,

allowing the eaves to stand vertically.

At this time, the cross-beam portion of the hip

end should be complete, with eave bars stand-

ing vertically, as shown (see fig. 4, above)

Caution: If you have attached liner ropes,

they should be kept at least partially coiled

to prevent them from becoming a trip

hazard during the remaining steps of the

installation.

(RH-30)

EAVE

REMAINING END

EAVES & HIPS

EAVE

R-30

E-15

(SIDE)

INSTALLING HIP EAVES